Brake Fluid Change
Service

Brake Fluid Change

Old brake fluid absorbs moisture and loses stopping power — a serious safety risk. We flush and replace your brake fluid to the correct DOT spec, restoring full braking performance and protecting your system from corrosion.

Overview

Brake fluid is hygroscopic — it absorbs moisture from the air over time. As water content rises, the fluid's boiling point drops, which can cause brake fade under hard use and corrode internal brake components. We fully flush the old fluid from the entire braking system and refill with fresh fluid to the correct DOT specification (DOT 3, DOT 4, or DOT 5.1) for your vehicle. Recommended every 2 years or as per your service schedule. A small cost that protects a system your life depends on.

What's Included
  • Full system flush
  • Correct DOT spec
  • Restores braking performance
  • Corrosion protection
  • Brake system inspection
  • Safety-critical service
Our Approach
01

Fluid spec & condition check

We identify the correct DOT specification for your vehicle and test the existing fluid for moisture content and condition.

02

Full system bleed & flush

Old brake fluid is bled from all four brake callipers or wheel cylinders until clean, fresh fluid runs through the entire system.

03

Fresh fluid fill

The reservoir is topped up with the correct DOT-spec fluid to the manufacturer's recommended level.

04

Leak & pedal check

We check for leaks at all bleed points, confirm a firm brake pedal, and inspect the system before returning the vehicle.

Reservations

Book Executive Service.

Secure your appointment at the studio. A service advisor will contact you shortly to confirm details and arrange concierge collection if required.

Preferred Time